News:

Check out the newsletters posted at our main club site:  http://57fordsforever.com

Main Menu

Boot cover

Started by oldgasser, 2018-01-16 21:05

Previous topic - Next topic

oldgasser

Looking for the 3 pcs of chrome hold down for the boot cover 1957/58 Ford Convertible.
Can you help?
Thank you for your time.
Ron.

KULTULZ

Do you mean the actual trim pieces or the clips/hold-down hardware?
MEL DIVISION - 1958-1960

MERCURY - EDSEL - LINCOLN

oldgasser

Mel I'm looking for the 3 hold down pcs.
Can you help?
Ron.

KULTULZ

Cataloging is showing the moldings as two-piece.

These are on the outside belt, correct? Can you provide a photo?
MEL DIVISION - 1958-1960

MERCURY - EDSEL - LINCOLN

KULTULZ

Here is an ILL. It is a generalized Ill as FORD deleted a lot of info from the FINAL PRINT 49/59 MPC.
MEL DIVISION - 1958-1960

MERCURY - EDSEL - LINCOLN

thomasso

Are you looking for the 3 pieces that the snaps for the boot are mounted to?   There are 3 pieces, center is stainless and outer curved pieces are die cast.  Spacers are needed between the rear piece and body to prevent denting, piece is held on by the snap screws.  Sorry my extras were beyond repair and discarded.  Good luck.
57 E Code Black 76B   55 Willys Aero   63 Rivera   99 Lightning  1- XK8 Convs.   05 Vanden Plas  etc.

Ray

I think I have 2 and a half sets of the die cast, none very good but salvageable. I'll look. No spares on the center stainless.
Willow Green 57 convert
Coral Sand over Gunmetal 57 "E" convert
"M" code 1969 Fairlane Ranchero
"Q" code 1969 Torino Cobra jet (427)
Inca Gold 57 Thunderbird