I need the input shaft bearing retainer, which is the part the throwout bearing rides on. I need one from either the narrow pattern toploader 4 speed or a 3.03 model three speed trans also 64 or earlier, toploader design trans. Let me know what you have and how much before I have a regular retainer turned down. The proper size for this part is 4 11/16 if you have one just laying around. Thanks in advance....
Is that a Borg-Warner trans? If so we have a Borg-Warner distributor here in town, if you have a part number I can check with him about the part.
No, this one is for the Toploader, or T&C trans. The BW part is easy to find, I am discovering. I found several on ebay, friends, etc. The `65 and later bearing retainer has an OD of 4 7/8, while the first year 64 retainer and early BW retainers have an OD of 4 11/16. I have an extra 65 retainer that I am taking to the machine shop tomorrow to get turned down to the smaller OD. I had a heck of a time trying to find a machine shop that would do it. I'm not trying to turn water into wine here, just trying to get my toploader ready to bolt up to my Y block, that's all.....
Found a local shop that turned it down for me. They turned it to 4 11/16, or 4.6875, and the fit was a little snug. If anyone else has this done, turn it to 4.685. I ended up taking some out of the center register with some sand paper, not a lot, just enough so the bearing retainer can fit without being forced, and possibly breaking mounting ears on my toploader.