4.6 coil on plug testing

[canadian_ranchero]

first picture shows the first test,set on 200 ohm, hook meter between small connectors.reading should be about .8 ohms.next picture, set meter to 20,000 ohms,go from one small connector to the spark plug connector, reading should be about 5300 ohms[5.30 on meter]last picture you go from the other small connector to the spark plug connector,5300 ohms[same reading as second test] hope this helps

[RICH MUISE]

Thanks for the info, Gary....I got mine all numbered and checked out today. I'm not sure what the acceptable ranges are, I only have the shop manual for a '95 Markviii.....On mine, the connector pins to spark plug connection ranged from 5.43-5.56 on 7 of them and 5.89 on one
You said the pin to pin ohms should be about 8 ohms..did you mean .8? your pic was a little fuzzy, but I think I see a (.) in there. mine all ranged from 1.1-1.4

[canadian_ranchero]

my meter was on the 200 ohm setting,so .8 ohms would be .8 on the meter.the ohms reading do vary a little.your reading are within the ranges i have seen[i said 8 ohm in my first post,should have been .8.i have updated it]

[RICH MUISE]

Sounds like I'm good to complete the cop swap. Thanks for your help. I still need to do final buffing on one of the coil covers.