Thanks for the info, Gary....I got mine all numbered and checked out today. I'm not sure what the acceptable ranges are, I only have the shop manual for a '95 Markviii.....On mine, the connector pins to spark plug connection ranged from 5.43-5.56 on 7 of them and 5.89 on one
You said the pin to pin ohms should be about 8 ohms..did you mean .8? your pic was a little fuzzy, but I think I see a (.) in there. mine all ranged from 1.1-1.4
my meter was on the 200 ohm setting,so .8 ohms would be .8 on the meter.the ohms reading do vary a little.your reading are within the ranges i have seen[i said 8 ohm in my first post,should have been .8.i have updated it]
Sounds like I'm good to complete the cop swap. Thanks for your help. I still need to do final buffing on one of the coil covers.