i ordered the kit and other parts to re weather strip door window and vent, how hard of a job is it?, or does it just take time?, thanks for any info
ok, tried that & no luck, so i'll go another way. has anyone ever put these seals in using the rivets?, is there a tool or do u make one up, is anyone has done this whats a good procedure, every bit helps. thanks
Gerald :006:
Got a pair of rear vent window rubbers right beside the confuser waiting for someone to answer you so I would not need to ask. To be truthful I haven't even really looked for a solution. The headliner install is more important.
TOM :unitedstates:
IN ONE OF DENNIS CARPENTERS CATALOGS IT SHOWS STEP BY STEP HOW TO DO THIS INSTALL. NOT TO HARD ,TAKES A LOT OF TIME AND YOU COULD USE A SECOND SET OF HANDS HOPE THIS HELPS TOM
My Dennis Carpenter catalogue has complete step by step procedure on replacing all
weatherstrip,anti-rattlers etc. Starts on page 88, hope this helps. Randy
i've seen the how to article in Carpenters, what i wanted to know was, has anyone worked with the rivits?, is there a tool or do i have to make one?, thanks
You might want to contact dennis carpenters about the rivets, on their tech-support line by phone, they can answer any and all of your questions.They have a great group of guys with a lot of knowledge on this type of stuff.Their tech no. is 1-704-786-8139 hope this helps!
thanks, i'll give them a buzz,
It is best to have two people to do the rivets. They say to use a rivet punch, not sure what that is. We just set the head of the rivet up so it is being supported. The more solid the better. Once you have the seal were you want it, use a dull center punch and softly hit the center of the rivet until it starts to mushroom out. Then I use a flat punch and tap the sides of the rivet down. The rivets are usually brass, and flatten easily, so you dont need to hit them very hard. If you do, they start to split and you cant get them to tighten up very well.
Ijust put a pair together, the DC article is good but pics are not up to par. definitly 2 man job rivets are easy we used center punch to spread rivet before hitting with flat punch and flatten them pretty good so as not to effect glass movement . not as hard as you might think
I agree with rockymountain about the extra hands and the punches. Did both sides of my custom 300
they turned out great. I also replaced the anty ratal window strips on the vent window tracks with rivits