Does anyone have any suggestions on replacing a steering column in a Custom with a tilt steering wheel?
You will not find anything that will fit with your present set up the steering shaft is part of the box . You need to have the shaft shortened [ by a certified person] and a rag joint put on than use the column of your choice. or here is another option http://57fordsforever.com/smf/index.php?topic=86.0 good luck :burnout:
T :walk:M :unitedstates:
Thanks so much for the info.
I found a site that has rack & pinion steering for 57 Fords and also power steering pump
Has anyone tried this particular set up?
http://www.wurthitdesigns.com/57Ford.htm
markman,
Several people have used the product. There are other products out there as well.
See my post in the General Tech Discussion section, Wurth-it vs. Gearheads 605 Steering Box .
Patrick
Dallas TX :unitedstates:
Patrick
Thanks so much for the information, I am not much of a mechanic myself, but am learning a lot. I've learned more from other people, such as yourself than anywhere. Again, thanks.
Mark
Iv'e had both p/s system,Wurth-it is the one that worked for me.
I have installed the Wurthit Designs setup and an IDIDIT steering column. See below. r