57fordsforever.com

Technical => General Tech Discussion => Topic started by: VwDrvFnd on 2014-03-03 13:20

Title: Pedal assemblies
Post by: VwDrvFnd on 2014-03-03 13:20
Can anyone tell me if there is a difference between the pedal assembly (gas/brake/clutch) of a car with a 3 speed manual with overdrive and a car with and automatic?
I am making a swap to an AOD and I need to ditch the clutch pedal, can I disassemble the stock pedal assembly and remove the clutch pedal or do I need to change the entire assembly to make it like a car that originally had an automatic?
Title: Re: Pedal assemblies
Post by: RICH MUISE on 2014-03-03 15:54
Can anyone tell me if there is a difference between the pedal assembly (gas/brake/clutch) of a car with a 3 speed manual with overdrive and a car with and automatic?
LOL...yup..the automatic only has one pedal!
I couldn't resist...sorry about that VW.
When I switched mine from the manual to automatic, I pulled an automatic pedal only out of a '61, and it fit perfectly, so I guess that's what your asking..you can just switch the pedals without switching the steering column/pedal/dash support bracket.
Title: Re: Pedal assemblies
Post by: canadian_ranchero on 2014-03-04 17:55
parts book says brake pedal arm is all the same.just bolt on the correct pedal pad
Title: Re: Pedal assemblies
Post by: VwDrvFnd on 2014-03-04 21:00
It looks like from this picture from the shop manual that it is as simple as pulling a clip and a bushing to remve the clutch pedal, and that all you have to do,is swap the pedal pads for the power brake pad.

(http://scontent-b-iad.xx.fbcdn.net/hphotos-frc3/t31/q77/s720x720/1978344_10202245503072782_1535810388_o.jpg)
Title: Re: Pedal assemblies
Post by: gasman826 on 2014-03-05 09:16
The clutch pedal has the pin fixed to it.  You will need to find an automatic pivot pin.  Ford petals were extremely similar so a pin will interchange from near 40 years of donors.  I have seen clutch pedals pushed to the floor and carpet over them!
Title: Re: Pedal assemblies
Post by: RICH MUISE on 2014-03-05 10:26
I vaguely rememmber struggling to get everything installed because of the retracting spring....and I was doing it on the bench. The nylon/plastic bushings get brittle with age, and new ones are available
Title: Re: Pedal assemblies
Post by: 65kcode on 2014-03-22 09:03
gasman826.. funny you say that, I was ready to pull the clutch pedals out of our parts car for the car we are building.  I decided to climb in the build car to see how it came out before climbing in the dirty mouse infested parts car.

What do I find shoved to the floor with the carpet layed over it?  Haha

Saved a lot of future health issues there!

Kevin
Title: Re: Pedal assemblies
Post by: gasman826 on 2014-03-22 10:55
Pedal under the carpet has been done many times.  I'm glad the 'heads up' saved you disturbing the mice.