I am dead in the water with my project till I get some stainless trim for both doors. I am probably going to change again as I think I found a set of Fairlane 500 doors that will have all the trim holes already in them, but the guy says they have no trim. I think it will be a lot easier than trying to weld the holes shut in the doors I have, then try to put the trim holes back in again for the Fairlane 500 trim pieces.
When I go to weld the quarter panel behind the door with the fin on it, I need to have the trim present so I can line it up perfectly. This is for my Ranchero turned Fairlane Ranchero project. I could also use the trim from the doors to the taillights on top of the fins, both sides.
It doesn't need to be perfect, I can fix the dents in it, just prefer not to have bad kinks in it. The car will be a driver, not a show car, so if you have something laying around that you don't want to use, I could probably use it. Thanks.
Also, if you happen to have a decent set of Fairlane 500 two door hardtop or convertible doors I might just consider driving maybe a thousand miles or so for a road trip.
John, I'm done restoring and have quite a bit of stainless trim parts here. I think I also have some doors, all 2DHt or RHT. I'v hauled 2 loads to the recycle, lots more to go. Hate to see it go to scrap but I have no more use for it. Contact info = awstadel@gmail.com or 406 855 7362, Take care, Alvin
Thanks for the reply. I will call you tomorrow sometime. You're not even that far away.