hi, yesterday my left hand turn signal stopped blinking, the lite is on, but no blinking, i've changed the bulbs and fuse , and its still not working, any ideas?, thanks jerry
Might sound strange, but I
This computer plays tricks on me. I would try a new flasher. If I remember correctly mine acted that way at one time and a new flasher did the trick.
Are the front and rear both on with no blinking? Sometimes when one bulb goes bad the other will stay on but not blink.
hi, the right works like it should, blinks, the left is just on, no blinking, changed bulbs and flasher fuse, still the left is on but no blinking
But did you check both left front and rear bulbs?
ok, this is what i did, i changed the flasher, i changed both front & rear bulbs, right side of car works like it should, left side the lite is on front and back but no blinking, i'm going out again and do everything over again to double check, other then what i've done i can't fix it, jerry WOW, am i screwed up, here i'm thinking i'm on the mustang site, and its the 57, things havn't been going right today
I've had them either flash quickly if a bulb is out or like yours, just stays on and doesn't flash.
Should be a 1157 bulb, park light / turn signal.
Nice 69 Mach 1 by the way!
Is it a bad ground/earth? Had something similar on a car a while ago and changed nearly everything before discovering the ligt wasn't grounding properly.
On that Mustang, Ford had changed to plastic turn signal sockets. The socket's ground fails. Usually shows up with the turn indicator light in the dash glowing (very dim) when the parking lights are on (turn signals off). The usual fix is to replace the socket. Last I checked, most auto parts have these from suppliers like Dorman.
With a test light clamped to a good ground, put the point of the test light against the metal base of the turn signal bulb with the turn signal on. The test light will light and turn signal bulb will start to blink if there is a bad ground. Slide the point of the test light in the ground side of the back side of the socket. If the test light does NOT light and turn bulb start blinking...socket is bad.
i'll give gasman's idea a try, l u know what happens, thanks jerry
ok, said i would give a feedback on what happened. turns out it was the back tail lite socket, had the orig socket, so the wires were old and wrinkled and wouldn't spring back to hold the lite bulb right, one wire was frozen in place and didn't move to make contact with bulb, i suppose if i knew that i cold have played with it and made it work, thats why theres guys out there making a living to help with our unknowledge of things