My 57 project has a heater control valve installed in the engine compartment. Where do I buy a cable to fit it? The original is way to short.
Unless our car is a custom with a box heater the original valve was mounted on the core under the right side of the dash which would be too short. Auto suppliers sell universal choke cables or at least used to when there were manual chokes. There were several valve configurations of water control valves which are all available. You should get manuals
I needed a cable with the "barrel" ends on it to attach to the heater dash control and the actual valve. The problem was trying to find a cable the correct length Most catalogs do not list the actual length of the cable. I finally found one that may be a little long but better than too short. Plenty of room under the dash to take up the slack. Cable will arrive Tuesday so then should be good to go.
Buckaroo,
Where did you find the cable?
I found one at Mac's. I believe it is about 60" long. I ran it through an opening by the right firewall/ fender well to the valve. My right air air vent cable works very hard but can't seem to find one with the knob attached. Trying to free it up. Lots of challenges with this car.
Thanks
Buckaroo, there is a rust dissolver out there that is fantastic. Non caustic, cleans with water and leaves bare metal. It will not harm the plastic knob. I used it to free up the heater control cables on my Edsel. Then use a Teflon lube (Lowes had it) to lube up the cable. It comes in a 1/2 pint plastic clear bottle. The actual lube is settled in the bottom of the bottle. A little pricy for the size of the container but it is well worth the cost.
Take a look at controlcables.com 562 949 0455 They might have a cable you can use.