I have most of the door internals installed. I'm having trouble figuring out where the third peg/roller goes for the window regulator. I realize that two of the rollers go into the window channel at the bottom of the glass. I've looked in the shop manual but didn't get any clarity. Any help is greatly appreciated.
Terry: As I recall there is a short roller channel bolted inside the door. About 8- 10 inches long that roller goes into. Put in last.
Thank you. I couldn't figure it out as I was looking for a welded in piece.
After searching through several boxes of parts and not finding the missing run, I looked in the other door only to find the run was welded in place. I wasn't looking in the correct area but it wasn't visible in the partially assembled door. About 40 minutes later I had the glass installed and working properly only to discover the top edge of the glass near the rear edge cut 1/4" short.
I need to get someone knowledgeable to check my adjustment on the mechanism. If my adjustment is correct, I'll take it apart and have another pair of door glasses cut.
I truly appreciate all the assistance I get form the members here!
A quick little update. I am having the door glass re-cut.