57fordsforever.com

Technical => General Tech Discussion => Topic started by: texasmark1 on 2008-11-30 09:02

Title: timing marks on damper
Post by: texasmark1 on 2008-11-30 09:02
still trying to get my first start up to happen...

wondering about the relationship of the timing marks and the keyway location on my damper...

when I have #1 piston at TDC, I believe the timing marks should be somewhere in the vicinity of the pointer, correct?

mine are at about 7 or 8 o'clock with #1 at TDC; the pointer is at approx 10 to 11 o'clock...

am I crazy or is something off?
Title: Re: timing marks on damper
Post by: 4banger on 2008-11-30 10:06
Get an old spark plug. Gut it out and put a solid rod in it. Say 2" long. Put in #1 hole. Bring piston up by hand till the piston touches, put a mark on dampner. Turn motor by hand the oppsite way till piston touches again. Mark dampner again. Between the two marks  is the exact dead center. You might get at it better from underneath.
Title: Re: timing marks on damper
Post by: Hoosier Hurricane on 2008-12-01 05:44
Mark:

You don't say what engine you have, but I'm guessing it's a Y Block.  The marks are on a ring that is rubber mounted to the front pulley, and as the rubber ages the ring has a tendency to slip.

John
Title: Re: timing marks on damper
Post by: texasmark1 on 2008-12-01 18:25
yep, its a 272...
I was trying to find out if the relationship between the timing marks and the slot for the key way is always the same, in other words,

if the timing marks are, for example, at 10 o'clock and the slot is at 3 o'clock, will this always be the orientation for every damper...

thanks, Mark
Title: Re: timing marks on damper
Post by: Hoosier Hurricane on 2008-12-02 05:42
Mark:

As far as I know, they would all be the same.  On another site a guy posted that if the keyway is at 6 o'clock, the 12 degree timing mark would be at the center of the spoke that is at about 10 o'clock.  This is looking at the damper from the front side.  With this rule of thumb, it appears your marks are off about 90 degrees.  If it is off precisely 90 degrees, you could time it by hooking your timing light to #2 or #8 cylinder.

John