Intake manifold

[Ford Blue blood]

I have a 292 in a 61 F100.  The intake has a little 4bbl manifold and will not take my Holley.  The casting number is ECZ - 9425 - A.  I need a regular 4bbl manifold that will take the Holley.  Anyone out there that has one that is close enouph to Rosamond, CA to meet up with?  I am in southern CA at my daughters place in Rosamond and sure could use a little help.  She and her husband are no motor heads but she was able to round up some tools to work this thing.  My cell is 205-382-7135.  Thanks in advance!  Bill

[Zapato]

Bill, go to the HAMB board with this request, hundreds of guys online at any time, would be more likely to get a response. Find it at the Jalopy Journal the click on to the HAMB, tell them Zapato sent you there. Lots of Y-block guys on that site. Good Luck!

[Ford Blue blood]

Thank Zapato, been there, done that, just starting to check the boards so don't know if anyone has responded.  We'll see, may just have to drag it back......

[KidKourier]

   Bill, I've got a "ECZ-9425-B" manifold that takes the Holly(I was running a Holly 600 cfm on it). I believe I'm about 200+ miles from you south below San Bernadino/Riverside in Hemet,Ca.(just south/east of the old March Air Force Base),don't know if this is to far for you to go,but if your interested we can try to work something out! KID

[Ford Blue blood]

Found an adaptor (Edelbrock # 1106), works perfect.  It is buried in their catalog in the flat head section, no mention of it in the "adaptor" section.  Thanks for the replies and offers....hope to fire this bad boy up today...

[rmk57]

 KidKourier I sent you  PM about your intake.

[KidKourier]

    Got it! Back atcha. KID