Parts

[hiball3985]

Jim - you probably already know that the spare tire hold down (spare behind the seat) in a Ranchero is different that the one pictured.

Thanks Bill, I knew that but I'm not putting it behind the seat, it's going in the bed.

[BWhitmore]

Jim - a thought.  If you are going to mount the spare flat in your bed you might want to think about removing one of the bolts holding down the bed plate.  Substitute a threaded rod (5/16), mount the tire over the threaded rod with a flat plate and wing nut to secure everything down.  The stock spare location uses a round plate and large wing nut to secure the spare to the rod extending from the bracket.   The round plate is fairly common up through the Mustang years.  This strategy would eliminate the need to drill a hole in your bed. 

[hiball3985]

Jim - a thought.  If you are going to mount the spare flat in your bed you might want to think about removing one of the bolts holding down the bed plate.  Substitute a threaded rod (5/16), mount the tire over the threaded rod with a flat plate and wing nut to secure everything down.  The stock spare location uses a round plate and large wing nut to secure the spare to the rod extending from the bracket.   The round plate is fairly common up through the Mustang years.  This strategy would eliminate the need to drill a hole in your bed.

Thats another possibility Bill. I'm not sure if there is enough room between the holes and side of the bed, I'll have to measure that. I was just thinking of a small bracket held with some small screws that a the hold down bolt could be slipped in so I would only have two small holes. I have a few ideas kicking around in my head.

[mtwilsonboy]

Can anyone use any of the parts in this picture?  FYI, the Windshield Wiper Motor is a 57 Chevy 12 volt. Part Number 5047905.

I would be interested in the two outer bumper brackets. How much are you looking to get? My email address is rreigert@yahoo.com.

[Ecode70D]

Wighty
Email has been sent.
Jay

[Zapato]

Wighty, email sent

Zap-