FE Hedman headers

[rmk57]

I wouldn't mind seeing a set of these hedman headers and find out what they did differently. I have about 4" or so clearance with car at rest, when you jack the car up there's about 3/4" between the header tube and tie rod with all the suspension hanging down. I built my own crossmember as I didn't want to cut up my original and my collectors go underneath it.

Having all four 2"inch tubes go over top the control arms would be an engineering marvel. I did this with the old y-block and 1 1/2" tubes and it was a tight squeeze.

Fender well headers maybe an option.

[JPotter57]

you can move a tube or two on 67-68 Mustang FE headers and they will work.  I have seen a pair done.  The Hedman headers I believe are only 1 3/4 tube.  2" tube headers would never work without putting one or two tube on each side outside the frame rails.   You can look at Bob Lewis car to see how that is done, but those are big tube 429 type headers for 70-71 Torino.  Not sure if that would work for the similarly built big tube FE headers for 68-69 Torinos.