Transmission mount

[nitro3847]

anyone know what transmission mount for a c4 that will match the holes in a 57 crossmember

[abe_lugo]

On my old rig.  It original was converted to an AOD.  So the crossmember was notched and boxed then a plate was added on top and we drilled some holes.  Used the stock mount.  When we went to the C4.  Believe the holes still lines up.  Some a matter of adding a plate and drilling some holes.  I will have crawl under and take a pic.

[RICH MUISE]

With Abe's post on the AOD in mind, when I notched and altered my cross-member for the 4R70W, the holes ended up within 1/16 of where the originals were. May not mean anything other than Ford apparently strived for consistency for lots of years. I think the actual mount I ended up using was from a 90's Crown Vic

[Ford Blue blood]

I used a 2wd Explorer trans mount.  The cross member holes were 1/8" too narrow.  Used a file to widen them out.  The notch is to clear the AOD pan.

[RICH MUISE]

That looks like what I used, and probably was Explorer rather than Crown Vic, as I'm pretty sure Bill was the one that led me in that direction.

[villegas.mgl@gmail.com]

I used a 2wd Explorer trans mount.  The cross member holes were 1/8" too narrow.  Used a file to widen them out.  The notch is to clear the AOD pan.

Complete new guy here. Currently swapping my 292 to a 302 with a C4 transmission in my 57 Fairlane 500. What year Explorer trans mounts and cross member did you use?

[Ford Blue blood]

That should be a bolt in operation.  There are several motor mounts folks used and the transmission will bolt up with no changes.  Shift linkage is the only "custom" thing you'll need to worry about.

63/64 Galaxie 289 mounts, a later model fox body Mustang 302 mount, (can't remember the year) all work, some directly drop in, some with minor mods to the chassis mount holes.