ford o matic

wv 57s forever · 2012-09-19 21:51

does anyone make high stall torque converts for these trans?

Lou · 2012-09-20 10:17

Unless your building a car only to race, high stall converters are a bad idea. With that said, Ford FMX converter should work, as the FMX is a 3 speed Ford-0-matic.

Hoosier Hurricane · 2012-09-21 06:15

An FMX converter is not a direct bolt-in on a FOM. The FOM has to have the 29 spline input shaft, not the 17 spline. If it has the 29, then the FMX front pump has to be used, it's a direct fit. Then there is the front snout, the Y block or flathead snouts are different sizes than anything later that used an FMX. It becomes a custom built converter, any way you look at it. But it can be done.

John

wv 57s forever · 2012-09-21 18:33

anyone have a stall converter for a ford o matic that they would sell?

gasman826 · 2012-09-21 20:09

There are custom converter shops that rework your converter. A converter re-manufacturer might do it also. I have one local to me.

JPotter57 · 2012-10-08 17:09

So, Allan, what do you have going on up there in the mountains?

wv 57s forever · 2012-10-08 22:11

its not for me its for a older friend. no internet ability.

still got those armrests.

JPotter57 · 2012-10-09 13:37

Yeah, I just found the other one yesterdsy morning..pm me your address and they'll be on the way.

News:

ford o matic