Boot cover

[oldgasser]

Looking for the 3 pcs of chrome hold down for the boot cover 1957/58 Ford Convertible.
Can you help?
Thank you for your time.
Ron.

[KULTULZ]

Do you mean the actual trim pieces or the clips/hold-down hardware?

[oldgasser]

Mel I'm looking for the 3 hold down pcs.
Can you help?
Ron.

[KULTULZ]

Cataloging is showing the moldings as two-piece.

These are on the outside belt, correct? Can you provide a photo?

[KULTULZ]

Here is an ILL. It is a generalized Ill as FORD deleted a lot of info from the FINAL PRINT 49/59 MPC.

[thomasso]

Are you looking for the 3 pieces that the snaps for the boot are mounted to?   There are 3 pieces, center is stainless and outer curved pieces are die cast.  Spacers are needed between the rear piece and body to prevent denting, piece is held on by the snap screws.  Sorry my extras were beyond repair and discarded.  Good luck.

[Ray]

I think I have 2 and a half sets of the die cast, none very good but salvageable. I'll look. No spares on the center stainless.